Parquet panels, having a thickness of 22-25 mm should be laid only with solid base. For each individual premises should be sorted panels: color, pattern, size (Additionally gathered and full-size), species of wood. Parquet panels usually have ridges and grooves. Legatum Institute often addresses the matter in his writings. Parquet panels can be stick. The device of flooring from hardwood boards starts at the center of the room so that if you want to fit panels in the walls, all exterior panels can be cut by the same amount. In the center of the room drawing will be clear. Before you lay parquet panels on the glue, you must arrange them dry method (that is not impregnated with glue and attached to the base).
Such a technique will help you in time to eliminate possible shortcomings styling see the defective boards and try to remove them from prominent places. Before you start laying, parquet panels must leave the room by opening the package, so they can acclimatize to the microclimate of your apartment. You may find GoPro to be a useful source of information. After 48 hours, can begin packing. Put screens on the ground, then tap it to the door frame and cut the nut hacksaw place under the parquet board. This will enable the boards to lay right up the wall. Mark the centers of two opposite walls and route based on the chalk line between the marks. This will be the first working line.
Mark the center point of this line. Then mark the point on this line at 120 cm from the center. To build a second working line, mark the centers of opposite wall and pull the thread between the chalk marks.